LIGHTING POLES PRODUCTION
AND ELECTRICAL EQUIPMENT

CONICAL CURVED SHEET STEEL METAL POLES

The curved conical poles are constructed from sheet metal by bending of circular trapezoid steel plate S235JR (EN 10025).
The longitudinal edges facing after bending are welded by automated process certified by RINA.

At each pole are made of the following operations:
- Cable entry slot;
- Implementation of the pocket ground;
- Terminal board slot.


All poles, thanks to the taper 10% ending at the top , with 60 mm dm are suitable for installation of a street lighting.

Subsequently, the straight poles are subjected to cold bending on suitable jigs and by the action of an electric winch, will assume the curvature requirements.

The galvanization of materials is achieved by immersion in baths of molten zinc which the thickness of the zinc layer is in compliance with UNI EN ISO 1461.

The poles are made in compliance with the UNI EN 40-5 standards and associates:
- Dimensions and tolerances: EN 40-2;
- Materials: EN 40-5;
- Specification for characteristic loads: EN 40-3-1;
- Verification by calculation: EN 40-3-3;
- Surface protection: EN 40-4.

working poles up to 6 meters in height

- insert pocket-earth place to 600mm from pole base
-132x38-loop cables placed at 350mm
-132x38-door mail slot to 1500mm from bottom of the pole in the center hole

working poles taller than 6 m

- pocket-grounding pole placed at 900mm from base
-186x45-loop cables placed at 600mm from bottom of the pole in the center hole
-186x45-door mail slot to 1800mm from bottom of the pole in the center hole

 

At the request of the customer performing special processing to the posts:

-Door cur flush with pole
-Square or circular base plate. Dimensions and thickness on request according to the type of application and type of pole
-Coupling with decorative reduction rings
-drip-ring or stop
-Reinforced door slot where necessary
-welded steel sleeve or shrink sleeve applied
-adjustable arm or flange
        
At the request of the customer the finish of the pole can 'be powder coated according to RAL international scale.

All poles are supplied with label and or CE marking.